Page 7-128 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Air in Fuel (Cont) Attach a preferably clear hose to the outlet of the fuel filter. (Do not use pressure test fitting.) Place a pressure gauge on the inlet side of the fuel filter and a vacuum gauge on the inlet side to the transfer pump. Insert a hose into an empty 3.8-liter [1-gal] container. Operate the fuel lift pump by bumping the starter. (The lift pump should run for 25 to 30 seconds.) Check for bubbles in fuel. Record filter inlet pressure and transfer pump inlet restriction. If filter inlet pressure is greater than 34.8 kPa [5 psi], the filter element must be replaced. Repeat test.
If inlet restriction is greater than 152.4 mm Hg [6 in Hg] or 155.1 mm Hg [3 psi], then excessive restriction exists between fuel in the tank and the transfer pump, which must be repaired (e.g., fuel line or tank module). Repeat test. Drawing No. 9777, Section 7, Rev. 02-07