Section 7 – Adjustment, Repair, and Replacement Page 7-139 CFP83 Series Low Pressure Fuel Supply Lines Removal/Installation Refer to Fuel Supply Lines (41-006-024) in C Series Troubleshooting and Repair Manual, Bulletin No. 3666003. Prepare Low Pressure Fuel Line Thoroughly clean all fittings and components before removal. Make sure that the debris, water, steam, or cleaning solution does not reach the inside of the fuel system. Remove [Diaphragm Style Lift Pump] Disconnect the fuel line from the lift pump and filter head. Use two wrenches to disconnect the line from the lift pump. Remove [Piston Style Lift Pump] Disconnect the fuel line from the lift pump and filter head.
Use two wrenches to disconnect the line from the lift pump. Install [Diaphragm Style Lift Pump] Install the fuel line to the lift pump and filter head. Use two wrenches to tighten the connection to the lift pump. Torque Value: 24 N•m [18 ft-lb] NOTE : Do not over-tighten the connection. Fuel leaks can result from over-tightening. Drawing No. 9777, Section 7, Rev. 02-07