Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 10 – Maintenance Specifications Page 10-5 CFP83 Series Air Intake System Specifications NOTE : Engine intake air must be filtered to prevent dirt and debris from entering the engine. If intake air piping is damaged or loose, unfiltered air will enter the engine and cause premature wear. Exhaust System Specifications Electrical System Specifications Start Circuit The start circuit consists of a single starter motor and redundant starter control relays as well as using redundant power sources either 12 V or 24 V comprised of 12 V wet type storage batteries (optional at shipment).

The battery, starter and starter solenoid positive terminals are booted with a non-conducting cover or otherwise insulated from unintended grounding. Battery cable leads from the batteries to the designated connection points in the starting circuit are minimum 6.53 mm D. (No. 2 AWG), neoprene or rubber insulated with a 1.5 mm (0.060 in.) minimum insulation thickness rated 80 ° C (176 o F) minimum. The starter and starter solenoid are all metal enclosed. (1) Cold soak at -18 o C (0 o F) or above Drawing No. 9777, Section 10, Rev.

02-07 Recommended air cleaner element (Standard) K&N RU5045 (Optional) Donaldson B105006 Metric US Maximum temperature rise between ambient air and engine air inlet 15 oC 30 oF Maximum inlet restriction with dirty filter 635 mm H O 2 25 in. H O 2 Metric US Maximum exhaust back pressure imposed by complete exhaust system 10.2 kPa 40.8 in. H O 2 Exhaust pipe size normally acceptable 102 mm D. 4 in. D. Wiring for automatic starting (negative ground) Standard Reference wiring diagram 10423 (see Section 13) B.C.I.

Group Size 8D 12V 24V Minimum recommended battery cold cranking amperes (CCA)(1) 1250 Amps 625 Amps Minimum recommended battery reserve capacity 400 Minutes 800 Minutes Maximum resistance of starting circuit 0.002 Ohms 0.004 Ohms Typical cranking speed 120 RPM 120 RPM Alternator (standard), internally regulated 95 Amps 45 Amps Battery Cable Size (Metric) (For less than 1.5 meters long) 10.6 mm D. 10.6 mm D. Battery Cable Size (US) (For less than 5 feet long) 00 AWG 00 AWG