Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 3 – Installation and Operation Page 3-27 CFP83 Series Initial Start-Up (Cont) Drawing No. 9777, Section 3, Rev. 02-07 Remove the coolant tank cap. Check coolant level. Cold coolant level should be between the bottom of the tube and above the top of the heat exchange coils. Add coolant if necessary. Use a mixture of at least 50 percent antifreeze and 50 percent water. Replace the coolant tank cap. Make a visual check for coolant leaks. Prime the Fuel System: Fill the fuel filter (see Fuel Recommendations and Specifications in Section 10). Remove the fuel pump suction line and wet the gear pump gears with clean lubricating oil. Check and fill the fuel tanks.

Check the injectors to be sure they are properly adjusted.