Section 3 – Installation and Operation Page 3-31 CFP83 Series Initial Start-Up (Cont) Drawing No. 9777, Section 3, Rev. 02-07 Supplemental Test Run Start the engine. Bring it to the fire pump required operating speed. Adjust the raw water pressure regulator to obtain the required pressure. Readjust the engine speed if necessary. Overspeed Adjustment Procedure: NOTE: Overspeed is already set at factory. Remove the calibrating screw cover from the electronic overspeed switch. Turn the small screw on the potentiometer near the word “OVERSPEED” clockwise to increase trip speed. Move the throttle to the half throttle position. Start the engine and move the throttle to the minimum position.