Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 3-36 Section 3 – Installation and Operation CFP83 Series Second Start The object of this test is to check that the engine operates normally with coolant temperature being maintained. Oil pressure is checked at rated speed. NOTE : Adjust engine operating speed as per Rated Speed Setpoint Adjustment below. Start the engine and observe that it is operating at rated speed. Check that the oil pressure is as specified in Lubricating Oil System Specifications in Section 10. NOTE : If oil pressure is not within the rated range, troubleshoot as per Lubricating Oil Pressure High or Lubricating Oil Pressure Low in Section 12. NOTE :

If temperature does not stabilize, stop the engine and refer to Coolant Temperature Above Normal or Coolant Temperature Below Normal (Engine Running) in Troubleshooting Section 12. Check that engine operating temperature stabilizes between about 82 and 95 o C [180 and 203 o F]. Shut off the engine. Correct any problems found before proceeding. Check the engine lubricating oil level. Refer to Check Lubricating Oil Level in Section 5. Top off if necessary. Check the coolant heat exchanger’s coolant level. Refer to Check Coolant Level in Section 5. Top off if necessary. Check the raw water strainer. Clean the strainer if necessary. Drawing No. 9777, Section 3, Rev. 02-07