Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 3 – Installation and Operation Page 3-41 CFP83 Series Overspeed Setpoint Adjustment and Testing Overview Overspeed setpoint adjustment and testing is a repetitive process. Use the Adjustment Procedure to change the setpoint. Use the Test Procedure to check the setpoint. Repeat the adjustments and checks until the desired setpoint is demonstrated. When the overspeed setpoint is successfully demonstrated, then check that the engine operates normally while not being tested. NOTE : The overspeed trip setpoint is displayed on the Factory Setting Tag described in Section 2. FACTORY SETTING NOTE : The overspeed setpoint must be set at between 115 and 120% of the engine’s rated speed.

ENGINE SPEED SETTING: (@ HP SETTING) OVERSPEED SWITCH SETTING: The speed switch located on the engine’s local control panel has a TEST button which lowers the currently adjusted overspeed by 10%. Thus, an overspeed setpoint of 2112 rpm would be reduced to (2112 * 0.9 =) 1901 RPM when the test button is pressed. Adjust the Speed Switch: Lower the cover on the engine’s local control panel. Disconnect the engine speed sensor signal from PICK-UP terminals 1 and 2. Connect a signal generator capable of providing between 0.25 to 120 VAC RMS signal to the switch. The signal must be proportional to the engine’s rated speed.

Provide an overspeed signal at the specified overspeed switch setting frequency. Drawing No. 9777, Section 3, Rev. 02-07