Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 3-54 Section 3 – Installation and Operation CFP83 Series Operating the Engine Monitor Operating Values Frequently Monitor the oil pressure and coolant temperature gauges frequently. Refer to Lubricating Oil System Specifications or Cooling System Specifications in Section 10 for recommended operating pressures and temperatures. Shut off the engine if any pressure or temperature does not meet the specifications. Do not exceed a maximum coolant temperature (93°C [220°F]). The pressure cap (or radiator cap) must meet the minimum pressure of 48 kPa [7 psi].

CAUTION Continuous operation with low coolant temperature (below 60°C [140°F]) or high coolant temperature (above 100°C [212°F]) can damage the engine. Verify raw water coolant pressure and flow. Monitor Engine Condition Periodically Most engine failures give an early warning. Look and listen for changes in performance, sound, or engine appearance that can indicate service or engine repair is needed. Some changes to look for are as follows: Engine misfires Vibration Unusual engine noises Fuel, oil, or coolant leaks Sudden changes in engine operating temperature or oil pressure Excessive smoke Loss of power An increase in oil consumption An increase in fuel consumption Drawing No.

9777, Section 3, Rev. 02-07