Kaiyi — 3. ELECTRICAL SYSTEM

10. WHEN SAFETY SOLENOID DOES NOT OPERATE · Before disconnecting the connector, always turn the starting switch OFF. · Before carrying out below procedure, check all the related connectors are properly inserted and short of fuse No. 26. · After checking, insert the disconnected connectors again immediately unless otherwise specified. FUSE No.26 SAFETY SWITCH 14 SAFETY SOLENOID 16 15 CN-4 CN-68 CS-4 900L6ES03 6-33 YES YES Check operation of solenoid NO Safety lever : ON-OFF YES Check voltage between CN-68 Check resistance (1) - (2) YES between CN-4 (16) and chassis Starting switch : ON Voltage : 20~30V YES Safety state Starting switch : OFF Safety state Spec :

0Ω Disconnect CN-4 Check resistance Check voltage between CS-4 between CN-68 NO NO (A)-(C) (2) and chassis Starting switch : OFF Safety lever : OFF Safety switch : ON-0Ω Starting switch : ON NO OFF-∞ Voltage : 20~30V NO Cause Remedy Hydraulic system malfunction Defective solenoid Disconnect in wiring harness or poor contact between CN-4-CN-68 Disconnect in wiring harness or poor contact between CN-4-CS-4 Defective safety switch Disconnection in wiring harness between CN-68 (2)-fuse No. 26 Check hydraulic system Replace Repair or replace (after clean) Repair or replace (after clean) Replace Repair or replace B C A A B C 2 1