Kaiyi — 3. ELECTRICAL SYSTEM

12. WHEN ENGINE DOES NOT START ( lights up condition) · Before disconnecting the connector, always turn the starting switch OFF. · Before carrying out below procedure, check all the related connectors are properly inserted and short of fuse No. 1, 7, 12, 22. · After checking, insert the disconnected connectors again immediately unless otherwise specified. CN-125 4 2 MASTER SW CN-5 35 CS-2 H 40 39 36 1 2 0, I 0 I 4 4 5 3 B 1 3 2 H BR ACC ST C 6 5 START KEY SW 6 CR-35 YES Check voltage CN-16 (1) and chassis YES 86 30 87a 85 87 YES 87 85 87a 86 30 Start switch : ON Spec :

20~30V NO POWER RY CS-74A Check operation start motor 2 1 Check voltage between starter magnet coil and chassis YES CR-46 Starting switch : START YES 90A CN-95 2 1 MASTER SW Starting switch : START Spec : 20~30V NO Check operation of start relay CR-23 NO YES YES Check voltage between CR-23 and chassis FUEL HEATER RY CN-147 2 1 CN-60 BATTERY CIRCUIT BREAKER 30A Starting switch : START Starting switch : START Spec : 20~30V NO CR-1 Check operation of engine ECM FUEL HEATER NO CN-16 BATT RY Starting switch :

ON DO-3 2 1 NO DIODE CR-23 START MOTOR EMS INTERFACE ENGINE ECM 1 2 M M FUEL WARMER RY 30 MCU CN-52 START RY CN-45 B+ CN-53 CR-5 KEY IG 24V 2 MCU 2 1 4 1 5 KEY IG 24V 2 CN-51 3 4 5 2 3 CONTACT INPUT 25 MCU CONTACT INPUT (LOW SIDE)RELAY 900L6ES11 6-35 No.7 No.12 No.22 Cause Defective ECM or battery Disconnection in wiring harness or poor contact between CR-35 (30) -CN-16 (1) Defective magnet of start motor Defective start relay Defective start relay Disconnection in wiring harness or poor contact between CR-23 -Engine ECM Defective engine ECM Replace Repair or replace Replace Replace Replace Repair or replace Replace 30 85 87 87a 86 87 85 86 30 87a 1 2 3 4 BATT.

ECM 1 2 3 4 5 6 7 8 GROUND IGN ECM BATT. ECM GROUND CAN SIGNAL HI CAN SIGNAL LOW ENG.RUNNING +24V