13. WHEN STARTING SWITCH ON DOES NOT OPERATE · Before disconnecting the connector, always turn the starting switch OFF. · Before carrying out below procedure, check all the related connectors are properly inserted, master switch ON and check open circuit of fusible link (CN-60). · After checking, insert the disconnected connectors again immediately unless otherwise specified.
MASTER SW CN-125 4 2 CN-5 35 CS-2 1 H 40 39 36 2 3 0, I 0 I 4 H BR ACC ST C 4 5 B 1 3 2 6 6 5 START KEY SW CR-35 87 86 30 87a 85 87 85 87a 86 30 POWER RY CS-74A 2 1 CR-46 30 MASTER SW 85 87 87a 87 86 90A CN-95 2 1 FUEL HEATER RY 87a 86 30 85 2 1 CN-60 CN-147 30A BATTERY CIRCUIT BREAKER CR-1 FUEL HEATER CN-16 BATT RY DO-3 2 1 DIODE CR-23 START MOTOR M M EMS INTERFACE ENGINE ECM 1 2 FUEL WARMER RY 30 MCU CN-52 START RY CN-45 B+ CN-53 CR-5 1 KEY IG 24V 2 MCU 3 2 4 1 5 KEY IG 24V 2 CN-51 4 5 2 3 CONTACT INPUT 25 MCU CONTACT INPUT (LOW SIDE)RELAY 900L6ES05 6-36 No.7 No.12 No.22 YES Check voltage YES between DO-3 (2) and chassis Voltage :
20~30V YES Check voltage NO between CS-2 (2) and chassis Voltage : 20~30V Starting switch : ON Check voltage NO YES between CS-2 (1) and chassis YES Voltage : 20~30V Check voltage between CN-5 NO Check voltage (36) and chassis YES and specific gravity of battery Voltage : 20~30V Check voltage between Specific gravity : MIN 1.28 NO CS-74B (1) and Voltage : MIN 24V chassis Voltage : 20~30V NO NO YES Check voltage ⓐ between CS-74A (2)- chassis NO Voltage :
20~30V Cause Remedy Disconnection in wiring harness or poor contact between DO-3 (2)- CR-1 or defective battery relay Disconnection in wiring harness or poor contact between CS-2 (2)- CN-5 (39)- DO-3 (2) Defective start switch Disconnection in wiring harness or poor contact between CS-2 (1)- CN-5 (36) Disconnection in wiring harness or poor contact between CS-74B (1) -CN-5 (36) ⓐ Battery capacity too low Defective master switch Disconnection in wiring harness or poor contact between CS-74A (2) -CR-1 Repair or replace (after clean) Repair or replace (after clean) Replace Replace Charge or replace (after clean) Charge or replace (after clean) Replace Charge or replace (after clean) 1 2 3 4 BATT.
ECM 1 2 3 4 5 6 7 8 GROUND IGN ECM BATT. ECM GROUND CAN SIGNAL HI CAN SIGNAL LOW ENG.RUNNING +24V