15. WHEN STARTING SWITCH IS TURNED ON, HEAD LAMP DOES NOT LIGHTS UP CR-13-1 · Before disconnecting the connector, always turn the starting switch OFF. · Before carrying out below procedure, check all the related connectors are properly inserted and short of fuse No.14 and 21. · After checking, insert the disconnected connectors again immediately unless otherwise specified.
30 30 86 86 87 85 87a 85 87 87a HEAD LAMP RY CL-24 HEAD LAMP-REAR CL-23 HEAD LAMP-REAR FUSE CR-13 30 30 86 No.21 86 87 85 87a 85 87 87a HEAD LAMP RY CL-3 HEAD LAMP CL-4 HEAD LAMP FUSE CL-4A No.14 HEAD LAMP CN-376 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 INT WIPER/OUT R LH WIPER/OUT R RH WORK LIGHT CABIN LIGHT OVERLOAD SW WASHER/OUT F LH HEAD LIGHT BEACON LAMP IG 24V CAN HI(2) CAN LO(2) GND GND NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC NC RDU(RELAY DRIVE UNIT) 900L6ES07 6-38 YES Check voltage between CL-3 (1), YES CL-4 (2), 4A (1) CL-23 (1), CL-24 (1) and chassis NO Voltage :
20~30V Check voltage between CR-13 YES (87) and chassis, CR-13-1 (87) and chassis Starting switch : ON Head lamp switch : ON Voltage : 20~30V NO Check voltage Check voltage between CR-13 between CN-376 (30,86) and NO chassis, CR-13-1 (13) and chassis (30,86) and chassis Starting switch : ON YES tarting switch : ON Head lamp switch : ON oltage : 20~30V Voltage :
20~30V NO Cause Remedy Defective bulb Disconnection in wiring harness or poor contact between CR-13 (87)-CL-3 (1) or CL-4 (2), CL-4A (1) or CR-13-1 (87)- CL-23 (1), CL-24 (1) Defective relay drive unit Disconnection in wiring harness or poor contact between CN-376 (13)-CR-13 (87), CR-13-1 (87) Defective head lamp relay Disconnection in wiring harness or poor contact between CR-13 (30,86) and fuse No.21 or CR-13-1 (30,86) - fuse No.21 Recheck fuse No. 21 Replace Repair or replace (after clean) Replace Repair or replace (after clean) Repair or replace (after clean) Replace 1 2 1 2 2 1 2 1 2 1