Kaiyi — 3. ELECTRICAL SYSTEM

16. WHEN STARTING SWITCH IS TURNED ON, WORK LAMP DOES NOT LIGHTS UP · Before disconnecting the connector, always turn the starting switch OFF. · Before carrying out below procedure, check all the related connectors are properly inserted and short of fuse No.14 and 18. · After checking, insert the disconnected connectors again immediately unless otherwise specified.

FUSE CR-4-1 30 30 86 No.18 86 87 85 87a 85 87 87a WORK LAMP RY CR-4 30 86 30 86 87 85 87a WORK LAMP RY 85 87 87a CL-5 WORK LAMP CL-6 CL-36 FUSE WORK LAMP No.14 CL-37 CN-376 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 WIPER/OUT R RH WASHER/OUT F LH INT WIPER/OUT R LH WORK LIGHT CABIN LIGHT OVERLOAD SW CAN HI(2) HEAD LIGHT BEACON LAMP CAN LO(2) IG 24V NC NC NC NC NC NC NC NC NC NC NC NC NC NC GND GND NC NC NC NC NC NC NC RDU(RELAY DRIVE UNIT) 900L6ES18 6-39 YES Check voltage between CL-5 YES (2), CL-6 (2), CL-36 (2), CL-37 (2) and chassis NO Check voltage YES between CR-4 (87), CR-4-1 (87) and chassis Starting switch : ON Work lamp switch :

ON Voltage : 20~30V NO Check voltage between CN-376 NO Check voltage (4) and chassis between CR-4 (30,86) and Starting switch : ON chassis, CR-4-1 Work lamp switch : ON YES Voltage : 20~30V (30,86) and chassis Starting switch : ON Voltage :

20~30V NO Cause Remedy Defective bulb Disconnection in wiring harness or poor contact between CR-4 (87)-CL-5 (2), CL-6 (2) or CR-4-1 (87) - CL-36 (2), CL-37 (2) Defective relay drive unit Disconnection in wiring harness or poor contact between CR-4 (85)-CN-376 (4) or CR-4-1 (85) - CN-376 (4) Detective work lamp relay Disconnection in wiring harness or poor contact between CR-4 (30) and fuse No.18 or CR-4 (86) and fuse No.18 Recheck fuse No.18 Replace Repair or replace (after clean) Replace Repair or replace (after clean) Repair or replace (after clean) Replace 1 2 1 2 1 2 1 2