3. SWING DEVICE 1) HYDRAULIC MOTOR (1) Service limit Replace parts in accordance with the standards. However, if a part is damaged significantly in terms of its appearance, replace it irrespective of the standards. 900L7SM01 (2) Renovation limit If the face roughness is found exceed the renovation limit, renovate or replace the parts. 1. Renovate face of parts by lapping below normal face roughness. 2. If set plate and retainer's face is no good, replace those parts as an assembly.
7-23 Part name and inspection item Standard dimension Recommended value for replacement Remedy Clearance between piston & cylinder bore D - d = 0.033 mm D - d = 0.045 mm Replace piston or cylinder block Clearance caulked part between piston & shoe δ= 0.0 mm δ= 0.3 mm Replace assembly of piston & shoe Thickness of shoe t = 7.0 mm t = 6.8 mm Replace assembly of piston & shoe Thickness of friction plate 2.2 mm 2.1 mm Replace friction plate d D t Part name Normal face roughness Renovation limit Shoe 1.6-Z (Ra=0.4) (lapping) 3-Z (Ra=0.8) Shoe plate 0.4-Z (Ra=0.1) (lapping) 3-Z (Ra=0.8) Cylinder 1.6-Z (Ra=0.4) (lapping) 12.5-Z (Ra=3.2) Valve plate 0.8-Z (Ra=0.2) (lapping) 6.3-Z (Ra=1.6)