Kaiyi — 2. MAJOR COMPONENT

⑤ The hydraulic motor slips too much Investigate the drain flow rate of the motor. If it is about 500 cm 3 /min or lower, the motor is considered to be normal. Oil leaks through mating faces 7-25 Phenomenon Possible cause Remedy Brake torque is insuffcient. ·Friction plate is worn. ·Breke piston sticks. ·Brake release pressure cannot be removed. ·Spline for frition plate is damaged. ·Disassemble and check it. Replace it, if worn more than criterion. ·Disassemble and check it. ·a) Check and repair circuit. b) Check time delay valve for brake. ·Disassemble and check it. Replace it, if damaged.

Phenomenon Possible cause Remedy When external driving torque is applied to motor, it slips too much ·Relief valve does not function well. Same as item ① ·Seat of plunger does not function well. ·Anti-reaction valve don't function well. ·Replace it. Same as item ① ·Replace it. ·Replace it. ⑥O il leakage Oil leaks f a. Phenomenon Possible cause Remedy Oil leaks from oil seal ·Lip catches particles of dirt and is damaged. ·Shaft is scratched or worn. ·Because of excessively-high casing internal pressure, lip of oil seal is turned up. ·Shaft is rusted. ·Replace oil seal. ·Shift lip/shaft contact position or replace them. ·If drain piping is clogged, clean it out. ·Disassemble and repair it. b.

Phenomenon Possible cause Remedy Oil leaks through mating face. ·O-ring forgotten to be fitted. ·O-ring is scratched. ·Seal surface is scratched. ·Bolts are loose or damaged. ·Fit it correctly and carry out reassembling. ·Replace it. ·Disassemble and repair it. ·Tighten then with specified torque or replace them.