(2) Simultaneously replaced parts This reduction gear is so designed that the parts are few in quantity and the life-spans of section are balanced with each other. Therefore, many parts should be replaced simultaneously as combinations due to constructional or functional reason, though any parts can be supplied independently. These are shown in table below. 1. Mark "O" show the part that must be replaced simultaneously. 2. Mark "X" show the part that is desirable to be replaced simultaneously.
7-27 Part to be replaced simultaneously 201 shaft Drive 401 402 203 230 282 286 910 2 10 231 283 285 287 403 909 Spherical rolle rbearing Spherical rolle rbearing Planetar ygea rNo.2 Carrie rNo.2 Pi nNo.2 Thrus twasher Sprin gpin Planetar ygea rNo.1 Carrie rNo.1 Pi nNo.1 Sid eplate Thrus tplate Needle cage Sprin gpin Part to be replaced 201 Drive shaft - o o 401 Spherical roller bearing x - x 402 Spherical roller bearing x x - 203 Planetary gear No.2 - x o x o 230 Carrier No.2 x - o x o 282 Pin No.2 x x - x o 286 Thrust washer x x o - o 910 Spring pin x x o x - 210 Planetary gear No.1 - x o x x x o 231 Carrier No.1 x - o x x x o 283 Pin No.1 x x - x x x o 285 Side plate x x o - x x o 287 Thrust washer x x o x - x o 403 Needle cage x x o x x - o 909 Spring pin x x o x x x -