Kaiyi — 2. MAJOR COMPONENT

(3) Part inspection and replacement criteria 7-28 ①Toot Whe (If the ②Oil S Whe Whe witho ※The f do no ③Beari Chec below a.Ch b. Sin - A - D - C If a sha ④Beari Whe ⑤Plan Chec If this ⑥Thru Whe ⑦Need Whe h faces of sun, planetary and ring gears: n pitting is found, replace the gear. pit size is 1mm or larger in diameter, and the area eal n the lip face is damaged or worn away, replace the n the reduction gear is disassembled for inspection ut fail. ollowing parts art those of the drive shaft assembl t disassemble it and inspect it as assembly. ng (the front side of the reduction gear) k the bearings without removing from the drive sh .

eck the outer race and rollers and confirm that they ce the inner race is behind the retainer and connot ren't there large wear particles in gear oil? on't large wear particles stick between the rollers a an the inner race be rotated smoothly by hand? ny abnormality is found during the above check, r ft should not be reused. ng (the rear side of the reduction gear) n they are pitting or flaking on the outer race and ro etary gear No.2 k the radial play of the planetary gear No.2 play is 0.5 mm or more, replace the pin. st washer, thrust plate n sliding face of thrust washer and thrust plate is sc le cage and pin No.1 n they art pitting or flaking, replace the needle cage