Fit back up ring (13) to rod cover (5). Put the backup ring in the warm water of 30~50 ° C. Fit O-ring (12, 14) to rod cover (5). ④ 12 13 14 ⑤ 900L8CY17 (2) Assemble piston assembly Check for scratches or rough surfaces. If found smooth with an oil stone. Coat the outer face of piston (16) with hydraulic oil. ① 8-158(2) Fit piston seal (17) to piston. Put the piston seal in the warm water of 60~100 ° C for more than 5 minutes. After assembling the piston seal, press its outer diameter to fit in. ② 17 900L8CY18 ③ 18 17 Fit wear ring (18) and dust ring (19) to piston (16). 19 18 19 ④ Fit back up rings (21) and O-ring (20) to piston (16). 16 20,21 900L8CY19 8-154