Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE dirt from inside the line filter as hydraulic circuit. For details, see "METHOD OF "BLEEDING AIR FROM HYDRAULIC SYSTEM (PAGE 4-39)". 4 - 36 CLEAN LINE FILTER, REMOVE DIRT If there other hydraulic follows Before removing t he line filter, release th e pressure inside the RELEASING PRE SSURE IN H YDRAULI C CIRCUIT (PAGE 1. Remove the co ver on top o f the pump Remove 4 bolt Remove 4 bolt the temporary Remove cover s (1), then re s (3), then te insertion hol (4) and was move flang mporarily s es (5) in co h filter (6). remove plug (7 of the case.

After washing f cover, and flan (9), (10), and ( 11) with new parts After assembli ng the filter a gain, bleed the air. Fo r details , see