4.2Manufacture of wiring harnesses Wiring harnesses are manufactured in accordance with customer-specific guidelines. Line and insulation crimping must take place together with the correct tools, where machine crimping is to be preferred. The notes provided in Annex 3 under Point A2 – A13 must be observed when pro- ducing the wiring harness. 4.3Installation of wiring harnesses The EDC wiring harness must be installed separately from other wiring harnesses. If spatial separ- ation is not possible, suitable measures must be implemented to ensure that no interfering pulses can penetrate the system from the outside. Avoid sharp bends and kinks during installation.
Protect the wiring harness from direct water spray. The quotation drawings should also be used as part of the installation instructions for the relevant wiring harnesses. The information provided under Points B1 – B10 must also be complied with (Annex 3). 123