The distance “A” must be small: +U Bat t MES 0 Control unit Actuating solenoid Inductive loads must not be disconnected by switches, relays etc. from the EDC control unit or battery positive terminal if it cannot be ensured that the inductance is canceled by suitable means. Otherwise, when the switch is opened, contact sparkover would occur which would couple interference onto all neighbouring lines of the wiring harness. The interference could cause the control unit to fail. If the EDC system is connected to another system (e.g. traction control), a system-dependent coupl- ing ground must be used to ensure that the effects do not cause mutual interferences.
These inter- ferences can be triggered by large potential offsets at the ground and pulse peaks. 128 A A