MAN Nutzfahrzeuge — Notes on design and assembly for wiring harnesses of electronic systems

Notes on design and assembly for wiring harnesses of electronic systems C. General information The following remedial measures are recommended in the case of little space in the recessed grip: 1. Use lines with an outside diameter of 0.35 mm 2 . 2. Use, multi-pole shielded lines (number of lines 2, e.g. joining several knock sensor lines), min. line cross section 0.35 mm 2 . 3. Join the shield potentials outside the recessed grip by means of a connector and lead single feeder line into recessed grip (see diagram). Block diagram The proposed measures should always be coordinated with the corresponding circuit and application department (e.g. due to EMC). 133