Freightliner — Freightliner Business Class M2 Workshop Manual

Cab Air Suspension 60.14 Height-Control Valve Replacement Replacement IMPORTANT: Before replacing the height-control valve, perform the steps in Subject 110 to see if the height-control valve is actually damaged or just out of adjustment. 1. With the vehicle parked on a level surface, apply the parking brakes and chock the tires. WARNING Do not disconnect any air lines in the cab sus- pension system without first blocking the cab securely. If the cab isn’t securely blocked, dis- connecting an air line could cause the cab to fall abruptly, possibly resulting in serious injury. 2.

Place blocks between the frame and the bottom of the cab, or use jack stands to keep the cab in position when the air spring is deflated. 01/27/2005 f602205 1. Height-Control Valve 2. Vertical Linkage 3. Air Spring 4. Shock Absorber 5. Horizontal Control Lever 3. Drain all air from the air tanks. Fig. 1, Cab Height-Control Valve WARNING tightening the nuts without holding the studs can back the studs out, causing a separation of the two halves of the valve body, and possibly a leak. Air lines under pressure can whip dangerously if disconnected under pressure. Drain all air from the air tanks before disconnecting air lines.

Dis- connecting pressurized air lines can cause per- sonal injury and/or property damage. 7. While holding the height-control valve mounting studs in place with an Allen wrench, remove the nuts and washers that attach the valve to the mounting bracket. Remove the height-control valve. 4. Remove the nut and washer that attach the verti- cal linkage to the horizontal control lever. Discon- nect the vertical linkage from the horizontal con- trol lever; see Fig. 1 . 8. Position the new height-control valve on the height-control bracket. While holding the height- control valve mounting studs in place with an Allen wrench, install the nuts and washers, and tighten 45 lbf·in (500 N·cm).

Do not overtighten. 5. Rotate and hold the horizontal-control lever up until all air is exhausted from the air spring. 6. Mark the air tubing to the height-control valve for later reference, then disconnect the tubing. 9. Connect the air tubing to the height-control valve. CAUTION 10. Align the vertical linkage with the horizontal con- trol lever and install the washer and nut. When removing or loosening a Barksdale height- control valve from a mounting bracket, always hold the valve-side mounting studs in place with an Allen wrench while loosening or tightening the nuts that attach the valve to the bracket.

Because the mounting studs are threaded into the valve body, loosening the nuts without holding the studs can tighten the studs, which can crush the valve body and damage the valve. Conversely, 11. Start the engine and run it until air pressure builds to at least 100 psi (690 kPa). 12. Check all air tubing and fittings for leaks. 13. Remove the cab supports. 14. Remove the chocks. Business Class M2 Workshop Manual, Supplement 14, September 2008 120/1 2 1 5 3 4