Cab Air Suspension 60.14 Shock Absorber Replacement Shock Absorber Replacement 1. Apply the parking brakes, shut down the engine, and chock the front and rear tires. 2. Place blocks between the frame and the bottom of the cab, or use jack stands to keep the cab in position when the shock is removed. 3. Remove the nut, washers, and bolt that attach the shock absorber to the mounting bracket on the cab. See Fig. 1 . 01/27/2005 f602205 1. Height-Control Valve 2. Vertical Linkage 3. Air Spring 4. Shock Absorber 5. Control Lever Fig. 1, Cab Height-Control Valve 4. Remove the nut, washers, and bolt that attach the shock to the mounting bracket on the cross- member, then remove the shock. 5.
Install the shock in the lower mounting bracket and install the bolt, washers, and nut. 6. Position the upper end of the shock in the mounting bracket and install the bolt, washers, and nut. 7. Tighten the upper and lower nuts 45 lbf·ft (61 N·m). 8. Remove the cab supports. 9. Remove the chocks. Business Class M2 Workshop Manual, Supplement 14, September 2008 130/1 2 1 5 3 4