Freightliner — Freightliner Business Class M2 Workshop Manual

Cab Heater and Air Conditioner, Valeo 83.00 General Information clutch. This happens when falling pressure drops below 25.6 to 31.2 psig (177 to 215 kPa). Normal compressor operation resumes when the pressure rises to 25.7 to 34.3 psig (177 to 236 kPa). Evaporator Probe The temperature of the evaporator is monitored by a variable resistance temperature probe. As the tem- perature of the evaporator increases, the tempera- ture probe resistance decreases. The evaporator temperature probe is connected to the control head, which controls operation of the refrigerant compres- sor through the bulkhead module in order to prevent the evaporator core from freezing.

When the evapo- rator temperature reaches 38.3°F (3.5°C), the control head sends a message to the bulkhead module to disengage the refrigerant compressor clutch. The refrigerant compressor will not resume operation until the temperature has risen above 40.1°F (4.5°C). Expansion Valve If the refrigerant system pressure rises above 426.5 to 483.5 psig (2941 to 3334 kPa), the binary switch shuts off the compressor clutch. When system pressure falls back to 313 to 426 psig (2158 to 2937 kPa), the compressor re- sumes operation. Blower Motor The brushless blower motor forces air through the HVAC evaporator, and through the duct work into the cab.

Climate Control Panel (control head) The expansion valve divides the high and low pres- sure areas of the refrigerant system. high pressure liquid refrigerant from the receiver-drier passes through the expansion valve, and moves into the low pressure area of the evaporator. See Fig. 1 and Fig. 2 . The fan switch, air selection switch, and the tempera- ture control switch are mounted on the climate con- trol panel, which is also called the control head. On HVAC systems with air conditioning, the air recircula- tion button is mounted on the climate control panel. A The climate control panel is controlled by a micropro- cessor and backlit with LEDs (light-emitting diodes).

Condenser B In the condenser, the hot refrigerant gas coming from the compressor turns back into liquid. As it con- denses to liquid, the refrigerant gives off the heat it has carried out of the cab. The heat goes out through the condenser tubing and cooling fins, to the air currents created by the engine fan and vehicle movement. Evaporator 1 Because the evaporator is an area of low pressure in the system, the boiling point of the refrigerant falls, which helps it absorb heat from the tubing walls and fins of the coils. As it absorbs heat, liquid refrigerant quickly boils and turns into a gas. 11/29/95 f830709 D C A. From the evaporator B. To the evaporator C. To the refrigerant compressor D.

From the receiver-drier As heat is absorbed through the outside surfaces of the evaporator, air passing over the unit loses its heat to these cooler surfaces. Moisture in the air condenses on the outside of the evaporator and drains off as water, dehumidifying the air in the cab. 1. Expansion Valve Fig. 1, Expansion Valve Refrigerant Lines Business Class M2 Workshop Manual, Supplement 18, September 2010 050/3