TwinFlow Fire Pump 90.00 Valve Removal, Disassembly, Assembly, and Installation 8.1 Align the transfer drum stop pin, the trans- fer bracket locating pin, and the transfer drum sleeve locating pin into proper posi- tion. 3. Disconnect both ends of the flexible hose that connects the water tank to the tank-to-pump valve. Then slide the flexible hose toward the water tank outlet or the tank-to-pump valve plumbing. 8.2 Install the transfer valve drum and bracket assembly into the pump body. NOTE: If the tank-to-pump valve is air-operated, drain the vehicles air system and disconnect the supply and the return line on the valve actuator, but do not remove the actuator from the valve.
Also, the tank-to-pump valve may be connected to the pump body by capscrews or studs with nuts. If studs are used, it may be necessary to remove some or all of the studs to remove the valve. If so, remove only the studs necessary to remove the valve, as any studs left will assist in realigning the valve during installation. 8.3 Apply Loctite ® 242 to the four 7/16–14 x 1-1/4 transfer bracket capscrews. Install and tighten 53 lbf·ft (72 N·m). 8.4 Slide the adjustment stem through the cover plate, the transfer indicator guide, and the support and transfer bracket. 8.5 Insert the stem drive gear in the transfer bracket, then slide the adjustment stem through the stem drive gear.
8.6 Insert the stem drive gear lock-pin into place, locking the stem drive gear onto the adjustment stem. 4. Remove the eight 7/16–14 x 1-1/2 capscrews that retain the tank-to-pump valve to the pump body. 8.7 Apply Loctite ® 242 to the transfer indicator guide setscrews. Install, but do not tighten them. 5. Remove the tank-to-pump valve and associated plumbing. 8.8 Turn the adjustment handwheel counter- clockwise until it stops. Make sure the transfer indicator is at the top of the slot- ted guide toward the transfer indicator, making certain that the transfer indicator engages the transfer indicator guide in the top groove. Then tighten the inside set screw in the transfer guide indicator.
NOTE: The back flow valve is a flat butterfly plate with two pivots attached at the top. These pivots fit into two open pivot sockets in the pump body. When the gasket is removed, the back flow valve may fall out. 6. Remove the old gasket from the pump body. 7. Remove the back flow valve. 8.9 Rotate the adjustment handwheel from stop to stop. The transfer indicator should move freely from the top to the bottom of the slotted guide in the cover plate. 8. Clean all of the gasket surfaces on the pump body and the tank-to-pump flange. 9. Install the back flow valve. Using two fingers, hold the pivots in the pivot sockets and check the valve for freedom of movement.
8.10 Tighten the outside setscrew in the trans- fer indicator guide, and recheck the move- ment of the transfer indicator. 10. Install a new gasket. 11. Apply Loctite ® 242 to the eight 7/16–14 x 1-1/2 capscrews and attach the tank-to-pump valve to the pump body. Tighten the capscrews to 53 lbf·ft (72 N·m). 9. Fill the pump, then test the valve for proper op- eration and leaks. Back Flow Valve 12. Slide the flexible connection hose so it is evenly spaced and secured on the water tank outlet and the tank-to-pump valve plumbing. 1. Drain the water tank and the pump. 2. Disconnect the control linkage at the tank-to- pump valve. 13. Attach the tank-to-pump valve controls and link- age.
Business Class M2 Workshop Manual, Supplement 8, September 2005 150/4