TwinFlow Fire Pump 90.00 Valve Removal, Disassembly, Assembly, and Installation 14. Fill the pump, then test the valve for proper op- eration and leaks. 10. Make sure the "up" arrow is aligned properly. 11. Apply Loctite 242 to the 7/16–14 x 2 sensing valve mounting capscrew. Tighten 40 lbf·ft (54 N·m). Sensing Valve 1. Disconnect the following lines at the sensing valve: 12. Connect all lines. Pilot valve discharge line 13. Fill the pump, then test the valve for proper op- eration and leaks. QG relief valve line TPM Relief Valve PG relief valve line Sensing valve pump suction line 1. Disconnect the line to the sensing valve and drain the fire pump. Make note of the wire con- nections. 2.
Remove the 7/16–14 x 2 sensing valve mounting capscrew. Drain lines 2. Disconnect the indicator light switch. 3. Remove the four 7/16–14 x 1-1/4 capscrews that attach the relief valve assembly to the pump body. 3. Remove the four 5/16–18 x 1 capscrews that attach the control body to the rear of the spring housing. Remove the control body, being careful not to lose the sensing valve spring. 4. Using a twisting motion, remove the relief valve assembly. 4. Remove the control valve from the sensing valve body. 5. To disassemble the valve, remove the indicator light switch, remove the cover retaining ring then slide the cover out of the relief valve body. 5.
Unscrew the sensing valve from the diaphragm, being careful not to damage the control valve. Remove the diaphragm. 6. Apply a small amount of pressure to the relief valve piston and remove the piston retaining ring. Carefully release the pressure held to the piston by the spring. 6. Before installing the sensing valve, clean all components. CAUTION 7. Remove the relief valve from the opposite end, sliding the relief valve stem out of the piston. Always remove the sensing valve suction inlet screen. Clean or replace as necessary. The screen is located in the suction side of the pump. Failure to do so may render components inopera- tive. 8.
Reach through the center hole of the piston and pull the piston out of the indicator switch end of the relief valve body. Then, remove the piston spring. 7. Install a new diaphragm on the diaphragm clamp. Apply Loctite 242 to the threads on the control valve, then install the control valve in the sensing valve body. 9. To assemble and install the valve, first clean and inspect all components. 10. Clean all sealing surfaces and install new O-rings seals. 8. Install the sensing valve spring in the valve body cover. 11. Install the relief valve in the relief valve body. 9. Apply Loctite ® 242 to the four 5/16–18 x 1 cap- screws, then attach the control body to the rear of the spring housing.
Make sure that the sens- ing valve spring properly aligns with the dia- phragm clamp. 12. Install the piston spring by sliding the piston in the relief valve body while at the same time slid- ing the piston on the relief valve stem. 13. Apply light pressure to the piston to compress the piston spring, then install the piston retaining ring. Business Class M2 Workshop Manual, Supplement 8, September 2005 150/5