SERDIA WHAT SHOULD YOU DO IF...? 2. Installing a new ECU with a factory-programmed engine data record. Every EMR has an engine-specific data record which is stored in a central computer at DEUTZ AG when the engine is de- livered to the customer. DEUTZ AG should be notified in the event of any changes being made to the settings in the EMR configuration. If you order a new ECU, it will be programmed with a data record to which DEUTZ AG has access under the appropriate engine number. ATTENTION! i.e. if you do not notify DEUTZ AG of any corrections to the engine settings, these cannot be taken into account when a new ECU is programmed.
Switch off ignition/power supply, Release the two plugged connections on the old ECU. Connect the ECU to the engine and the vehicle plug (both 25 pole). Switch on ignition/power supply. Call SERDIA program. Delete error memory in the menu "Error memory". Start engine and check for satisfactory running. 8.2.9 Error when entering configuration data This error message is triggered when SERDIA is unable to enter the hex file. It may be that the file contains umlauts (д, ц, ь) or certain special symbols that SERDIA is unable to read. 20-56