Deutz — ADJUSTING THE TENSION OF THE COMPRESSOR DRIVEBELT

AIR CONDITIONING SYSTEM MAINTENANCE OF THE AIR CONDITIONING SYSTEM The checks and servicing operations required for the air conditioning system are as follows: 1 - Checking the tension and condition of the compres- sor drivebelt. 2 - Discharging, flushing and recharging of the system using a specific servicing machine and R134 refrig- erant. 4 - Inspection and renewal of the electromagnetic clutch pulley (to be carried out at a specialised serv- ice centre). 5 - Removal and renewal of the receiver-drier. 6 - Removal and renewal of the condenser. 7 - Removal of the evaporator and the electronic tem- perature sensor. (For these operations see «REMOVAL OF THE AIR CONDITIONING EVAPORATOR»).

3 - Removal and renewal of the compressor. ADJUSTING THE TENSION OF THE COMPRESSOR DRIVEBELT Before adjusting the tension, carefully examine the drivebelt for signs of wear. The belt must be renewed immediately at the first sign of cracking, fraying or separation of the plies. If a new belt is fitted, re-adjust the tension after ap- prox. 15 operating hours. 1 - Remove the right-hand grille (1). 1 F0043951 2 - Loosen the screw (2) of the tensioner block (3) and loosen the nut (4) securing the compressor (5). 5 3 - Turn the rod (6) to obtain a belt deflection of: Static deflection ” A ” on first fitting: 13 mm belt: 550 ± 50 N 15 mm belt: 650 ± 50 N Static deflection ” A ” after 15 minutes:

13 mm belt: 400 ± 50 N 15 mm belt: 500 ± 50 N Use the same tool used for tensioning the the al- ternator drivebelt. The check should be carried out with the engine cold. 2 3 4 6 F0017302 4 - Tighten the screw of the tensioner block (3) and tight- en the nut (4) and bolt (7) to secure the compressor in position. 5 - Recheck the drivebelt tension. 4 7 F0017391 30-36