Deutz — 2. Positioning

FRONT SUSPENSION POSITION SENSOR REMOVAL AND POSITIONING OF THE FRONT SUSPENSION POSITION SENSOR 1. Removal 1 - Remove the cover (1). 1 F0017900 2 - Loosen the rear nut (2). 3 - Unplug the connector (3). 4 - Unscrew and remove the upper retaining bolt (4) of the support (5) and loosen the lower bolt (6); rotate the support (5). 4 7 2 5 - Remove the front nut (7) and remove the sensor (8). 3 8 5 6 F0017910 2. Positioning 1 - Start the engine, fully extend the front suspension cyl- inders and fit the sensor (8) to the support (5) with the front nut (2) fully unscrewed. 2 8 F0017930 5 2 - Fix the support (5) and push the sensor (8) in the di- rection ” X ” until the pin (9) is fully retracted.

3 - Keeping the pin in this position, screw in the rear nut (2) right up to the support (5). 9 7 2 8 4 - Screw the front nut (7) up to the support (5). 5 - Back off the nut (7) by one turn and tighten the nut (2) to secure the sensor. This adjustment prevents the possibility of the sensor sustaining impact damage at the end of its travel. 5 Nuts: 30 ± 6 Nm (22.1 ± 4.4 lb.ft.) X D0003930 30-111