Deutz — 3. Testing

FRONT SUSPENSION POSITION SENSOR 3. Testing T2 2 1 - Connect the test lead T2 (code 5.9030.743.1) be- tween the sensor (8) and the wiring (3); start the engine and, using a multimeter, check the voltage when the cylinders are in the mid-stroke position. Voltage with cylinders in mid-stroke position = 3.8V Fully retract the cylinders and check the voltage. Voltage with cylinders retracted = 1.90 1.95V The voltage is measured between the terminals of the brown (earth) and blue (signal) wires NOTE. The same reading can also be taken using the suspension section of the ART program.

(For details see ART in section 20) F0022062 2 - Stop the engine, disconnect the lead T2 (code 5.9030.743.1) and reconnect the wiring to the sensor. 3 - Refit the cover (1). 30-112