Deutz — TESTING THE LIFT POSITION SENSOR

LIFT POSITION SENSOR TESTING THE LIFT POSITION SENSOR Switch off the engine and remove the key from the ig- nition. 1 - Cut the retaining strap and, using a thin blade, dis- connect the connector (2) from the position sensor (1). 1 2 F0021410 2 - Connect the test lead T4 (code 5.9030.743.0) be- tween the connector (2) and the sensor (1). 3 - Start the engine and with a multimeter check that the supply voltage and the signal voltages with the lift rai- sed and lowered are within the specified ranges: Supply voltage (red-blue wires): 5.5 ± 1Vdc Signal voltage with lift raised (brown-blue wires): equal to or greater than 0.5Vdc Signal voltage with lift lowered (brown-blue wires):

less than or equal to 4.5Vdc T4 2 1 If the voltage readings are not within the specified ranges, renew the sensor. F0022071 30-133