LIFT POSITION SENSOR RENEWAL OF THE LIFT POSITION SENSOR Switch off the engine and remove the key from the ignition. 2 1. Removal of the position sensor 1 - Remove the screws (1) securing the cover (2) and the sensor. 1 F0020360 2 - Remove the sensor (3) and unplug the connector (4). 3 4 F0020370 2. Renewal of the position sensor bush (only if necessary) 1 - After removing the worn bush, clean and activate the seating. Activator: Loctite 7649 19є A 2 - Apply sealant to the surfaces of the hole and fit the new bush, aligning the machined guide surfaces of 19° manteining the protusion “A” of 4.5 0.5 mm. 0 -- 3 - Allow the sealant to cure for at least 30 minutes before fitting the sensor.
Sealant: Loctite 648 D000 4771 3. Refitting the position sensor Refitting is the reverse of removal. Before finally tightening the screws, rotate the sen- sor fully in a counter-clockwise direction; adjust the position sensor as described in the following paragraph. 30-134