Deutz — 4. Position sensor adjustment

LIFT POSITION SENSOR 8 - Check the adjustment by first lowering the lift (using external pushbutton (3)) to an intermediate position and then raising to the maximum height by holding the pushbutton pressed; the lift arms should stop before reaching the mechanical limit and thus over-pres- surising the hydraulic system, at which point the ref- erence marks should be the distance apart indicated in step 6. 3 If the hydraulic system is maintained at maximum pressure for more than 30 seconds during the adju- stment procedure, the system will automatically switch to neutral and the error code “37” will be si- gnalled.

In this case, before repeating the adjustment proce- dure, first turn the ignition key to the “ O ” position. F0021430 9 - If necessary, alter the position of the sensor by turning it a few degrees in a counter-clockwise direction. 30-136