Deutz — 4.1 CONFIGURATION

SERDIA MEASURED VALUES SERDIA negates CanRxObjActive in bits (inactive message) and then performs an AND combination with CanConf_bits in bits. As result one obtains in bits the receipt messages which are configured and inactive (CanRxTimeOutBits). A text is assigned to each bit of CanRxTimeOutBits, which represents the name of the relevant receipt messages. As not all bits may be used, it is defined in the text by entering "dc" for "don't care" that the text output is suppressed for this bit. If the text "100 Receipt message failed" is displayed, there is an additional text output of the list of missing receipt mes- sages. 3.6 EXAMPLE OF A DISPLAYED ERROR INFORMATION:

100 Receipt message failed Engine Temperature Engine Fluid Level Pressure Function shift Inlet / Exhaust Conditions 4. PARAMETERS 4.1 CONFIGURATION Via the menu item "Parameters" in the menu bar, you get to the "Configuration" screen. The configuration procedure is as follows: Scroll with keys "Next" and "Previous" to the page which contains the Parameter to be set (example: "AccPedal (SWG1)up. ref" on page 10: Setpoint gen. calibration values). Click on the field "New value" and enter the necessary numerical value. This must be between the indicated minimum and maximum. Click on "PC->ECU". All configuration data is transmitted to the ECU.

The data is now incorporated in the ECU and can be used for testing the engine setting. It is however lost upon shutting off the supply voltage. Save data record with the key "Save in ECU" (old data is overwritten). For checking purposes the data can be read out and displayed with the key "ECU->PC". Following satisfactory engine run the data record can be saved with the "Save in file" key on the hard disc or on a dis- kette. 20-20 VanRxTimeOutBit Text 0 Engine Temperature 1 Inlet / Exhaust Conditions 2 Engine Fluid Level /Pressure 3 TSC1 4 Engine protection 5 Function shift 6 Dc 7 Dc 8 Dc 9 Dc 10 Dc 11 Dc 12 Dc 13 Dc 14 Dc 15 Dc