SERDIA PARAMETERS 20-23 Assign config. top curve 0 2 0 Torque curve variants (2 variants✽), Perm, values: 0 = torque curve 1 1 = Switching betw. torque curves 1+2 Ass spec. eng. speed config 0 6 0 Setpoint eng. speed values (6 variants ✽) Perm, values: 0 = Only variable speed governing 1 = Switching betw. eng. speeds 1 and 2 2 = Switching betw. fixed / variable speed 3, 4 = Switching betw.speed variable / save: (3 = w. setp.speed, 4 = w. actual speed) 5 = two setpoint transmitters Ass droop config 0 3 0 Speed droop selection (4 variants✽) Perm, values: 0 = constant speed droop 1 = variable speed droop 2 = switching between speed droop 1 and 2 3 = switching betw.const.
/ variable speed droop Ass governor config 0 6 0 Type of governing (4 variants✽) Perm, values: 0 = Variable-speed governing 1 = Min-max-speed governing 2 = Switching betw.var./min.-max. speed governingx For the following 14 functions: On = 1, Off = 0 BoostPressSim (on/off) 0 1 0 Boost pressure simulation BoostPressMeas (on/off) 0 1 1 Boost pressure measurement EngSpeed sensor2 (on/off) 0 1 0 Redundant eng. speed sensing VehSpeedLimit (on/off) 0 1 1 Veh. speed limit CylinderShutoff (on/off) 0 1 1 Overrun cond. with overspeed LimpHomeOper 0 1 0 Limp-home upon control rod travel sensor failure Torque Indicator(on/off) 0 1 1 Torque computation (off: referred to torque curve, on:
torque curve point) SAME Output (on/off) 0 1 0 Customer-specific output function QuickCurrentDec (on/off) 0 1 0 BOSCH EDC inline p. (on/off) 0 1 0 TempMonitoring (on/off) 0 1 0 Temperature monitoring OilPressMon(on/off) 0 1 0 Oil pressure monitoring