. MAINTENANCE MAINTENANCE INFORMATION the mounting surface, and 4 - 3 Clean and replace the fuel filter frequently. specially the starting motor and alternator, to avoid accumulation of dust. Clean electrical components, e specially the starting motor and alternator, to avoi d accumulation of dust. When inspecting or changing th e oil, move the machine to a place that is free of d ust to prevent di rt from getting into the oil. Avoid Mixing Lubricants If a different brand or grade of oil h as to be added, drain the old oil and replace all the oil with the new b rand or grade of oil. Never mix different brand or grade of oil.
Cover on Right Side of the Machin e If the cover on the right side of the machine is fully opened and the boom is swung to the right, there is dang er that the boom may hit the cover and b reak it. right with the cover open, set the cover so that it is half-open. If the boom must be swung to the right with the cover open, set the cover so that it i s half-ope Locking the Inspection Covers Lock inspection cover securely in to position with the lock bar. If inspection or maintenance is performed with erforme inspection cover not locked in pos injury to the worker.
ition, there is a hazard that it may suddenly blown shut by the wind and cause and cause Hydraulic System - Air Bleeding After repairing or replacing the hyd raulic equipment or after removing the hydraulic p iping, it is necessary to bleed the air from the circuit. For details , see "CHANGE OIL IN HYDRAULIC TANK, CLE AN STRAINER ( PAGE 4-57)". Hydraulic Hose Installation When removing parts at locatio replace with new parts. When doing this, be careful not ns where there are O-rings or gasket seals, cle to forget to assemble the O-rings and gaskets.
When installing the hoses, do n ot twist or bend them into loops with a small radiu This will cause damage to the h ose and drastically reduce its service life. Checks After Inspection and Maint enance Works If you forget to perform the checks after inspection and maintenance, unexpected prob lems may occu r, and th is may lead to serious injury or property d amage. Always do the following: gine stopped) intenance points been forgotten? tenance items been performed correctly? n dropped inside the machine? It is particularly dangerous if parts are dropped aught in the lever linkage mechanism. ks? tightened?
en operating the engine, see "TWO WORKERS FOR MAINTENANCE WHEN E 2-35)" and pay careful attention to safety. tenance items working properly? or oil when the engine speed is raised? Checks after operation (with en Have any inspection and ma Have all inspection and main Have any tools or parts bee inside the machine and get c Is there any coolant or oil lea Have all nuts and bolts been Checks when operating engine For details of the checks wh ENGINE IS RUNNING (PAG Are the inspection and main Is there any leakage of fuel Use of Fuel and Lubricants Accord It is necessary to decide the type of fuel and lubricants according to the ambient tem perature.
For details, see Section "LUBRIC ANTS, FUEL AND COOLANT SPECIFICATIONS (PAGE