. MAINTENANCE LUBRICANTS, COOLANT AND FILTERS LUBRICANTS, COOLANT AND FILTERS HANDLING OIL, FUEL, COOLANT, AND PERFORMING OIL CLINIC 4 - 4 Oil Oil is used in the engine and hydraulic equip ment under extremely severe conditions (high temperature, high pressure), and deteriorates with the use. Always use oil that matches the grade and ma ximum and minimum ambient temperatures recommended in the Operation and Maintenance Manual. Even if t he oil is not dirty, always change the oil after the specified interval. Oil corresponds to blood in the human body, so always be careful when handling it to prevent any impurities n. aused by the entry of such impurities. et in when storing or adding oil.
uses of problems. (water, metal particles, dirt, etc.) from getting i The majority of problems with machines are c Take particular care not to let any impurities g Never mix oils of different grades or brands. Always add the specified amount of oil. Having too much oil or too little oil are both ca If the oil in the work equipment is not clear, th ere is probably water or air getting into the circuit. In such cases, please contact your Komatsu distributor. ated filters at the same time. of the oil periodically to check the condition of the machine. For ntact your Komatsu distributor. be necessary to shorten the oil change interval. e of the Komatsu oil clinic.
When changing the oil, always replace the rel We recommend you have an analysis made those who wish to use this service, please co When using commercially available oil, it may For this reason, we recommend making full us Fuel After completing the day's operations, fill the f uel tank to force out any air containing moisture. This will prevent the moisture from condensing and mixing with the fuel. f fuel containing water or dirt is used, it cannot work properly. when storing or adding fuel. and Maintenance Manual.
The fuel pump is a precision instrument, and i Be extremely careful not to let impurities get in Always use the fuel specified in the Operation Fuel may congeal depending on the temperat ure when it is used (particularly in low temperature below -15°C (5 °F)). It is necessary to use the fuel that is suit able for the temperature. Before starting the engine, or when 10 minutes have passed after adding fuel, drain the sediment and water from the fuel tank. If the engine runs out of fuel, or if the filters ha ve been replaced, it is necessary to bleed the air from the circuit. If there is any foreign material in the fuel tank, wash the tank and fuel system.
Cooling System Coolant River water contains large amount of calcium a nd other impurities, so if it is used, scale will stick to the engine and radiator, and this will cause defective heat exc hange and overheating. ng. ecautions given in the Operation and Maintenance Manual. Do not use water that is not suitable for drinki When using antifreeze, always observe the pr Komatsu machines are supplied with Komats u original anti-freeze in the coolant when the machine is shipped. This anti-freeze is effective in preventing corro sion of the cooling system. The anti-freeze can be used continuously for t wo years or 4000 hours. Therefore, it can be used as it is even in hot areas.
ful not to expose it to flame or fire. ccording to the ambient temperature. EAN INSIDE OF COOLING SYSTEM (PAGE 4-22)". cool before adding coolant. Antifreeze is flammable, so be extremely care The proportion of anti-freeze to water differs a For details of the mixing proportions, see "CL If the engine overheats, wait for the engine to