. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING (A) (B) When removing, disconnect the cable from the ground terminal first. When installing, connect the cable to the positive(+) terminal first. REMOVAL AND INSTALLATION OF BATTERY Before removing the battery, remove the ground cable (normally connected to the negative (-) terminal). If any tool touches between the positive terminal and the chassis, there is a hazard of sparks being generated. When installing the battery, connect the ground cable last. When replacing the battery, secure it with battery hold-down. Tightening torque:Tightening battery terminal:
9.8 to 14.7 Nm (1 to 1.5 kgm, 7.2 to 10.8 lbft) REMOVAL, INSTALLATION OF BATTERY CABLE 1. Open battery cover (1). 2. Before removing the battery, remove the ground cable (normally connected to the negative (-) terminal). If any tool touches between the positive terminal and the chassis, there is danger of sparks being generated. Loosen the nut of the terminal and remove the wires from the battery. 3. When installing the battery, connect the ground cable last. Insert the hole of the terminal on the battery and tighten the nut. Tightening torque: 9.8 to 19.6 Nm (1 to 2 kgm, 7.2 to 14.5 lbft) 4. Close battery cover (1), (2).
PRECAUTIONS WHEN CHARGING BATTERY When the charging the battery, if the battery is mistakenly handled, there is danger of explosion. Follow the precautions in "IF BATTERY IS DISCHARGED (PAGE 3-130)" and the instructions given in the charger manual, and always do as follows. 3 - 130 When checking or handling the battery, stop th e engine and turn starting key to the OFF position before starting. The battery gen erates hydrogen g as, so there is d anger of explosion . Do not bring light cause sparks. ed cigarettes near the battery or do anything that will Battery electrol yte is dilute sulph uric acid, and it w ill attack your clothes and skin.
If it ge ts on your clothe s or on your ski n, wash it immediately off with large a mounts of water. If it gets in your eyes, wash it out with fresh water, an d consult a docto r. Wear protective glasses and rub ber gloves when handling the battery. When removin g the battery, firs t disconnect the cable fro the ground (normally, from the negative (-) terminal). When installing, install the positive (+) ter positive termin sparks. minal first. If a tool touches the cable connecting the al and the chassis, there is danger that it will cause the use If the terminals are loose, there is danger that the defective contact may generate spark s that will cause a n explosion.
When installing the terminals, in stall them tightly Check the po removing or ins