Maintenance—Every 500 Hours Grease Swing Bearing Gear CAUTION: Prevent possible injury from unexpected machine movement if controls are moved by another person. Lubricating swing bearing gear and rotating the upperstructure must be done by one person. TX1001873A –UN–28DEC05 1. Remove swing bearing gear access cover (1). Discard gasket under access cover. 2. Grease must be 13—25 mm (1/2—1 in.) deep measured from the bottom of the ring gear. The grease must also be free of contamination by dirt and water. 650DLC Shown 1—Access Cover If the grease is contaminated, remove grease and replace with clean grease. IMPORTANT:
If water or mud is found in swing gear area, see Operating in Water and Mud in Section 2-3. 3. Add grease as required. IMPORTANT: Excessive grease can damage the swing gearbox seal. 4. Remove any excess grease from over the top of the swing drive pinion. 5. Clean surfaces, and install new gasket. 6. Install access cover. DW90712,0000019 –19–23JAN06–1/1 3-7-1 010609 PN=156