John Deere 450DLC, 650DLC, and 850DLC Excavators — Installing Boom Cylinder

Miscellaneous—Machine Assembly Installing Boom Cylinder IMPORTANT: Take care not to mix up the right and left cylinders. Install the cylinder with the cylinder tubes facing toward each other. T122529 –UN–05AUG99 1. Apply a film of grease to pin (B). 2. Lift up left side boom cylinder (C) with a crane. 450DLC—Specification Boom Cylinder—Weight 421 kg approximate ............................................. 928 lb approximate 650DLC—Specification Boom Cylinder—Weight 515 kg approximate ............................................. 1135 lb approximate 850DLC—Specification Boom Cylinder—Weight 850 kg approximate .............................................

1870 lb approximate T122530 –UN–05AUG99 CAUTION: When aligning the centers of the pin and pin hole, Do Not put fingers into the pin hole. When using a hammer, wear safety equipment such as safety glasses or a hard hat to protect against injury from flying pieces of metal. When inserting the pin, Do Not enter the area under the boom cylinder. T122531 –UN–05AUG99 3. Align pin hole (D) on the bottom side of the boom cylinder with pin hole (E) on the main frame to install pin. Take care not to damage the seal at this time. 450DLC—Specification Boom Cylinder Head End Pin— Weight 22.7 kg approximate ........................................................................

50 lb approximate A—Pin Lock Plate B—Pin C—Left Side Boom Cylinder D—Pin Hole E—Pin Hole F—Cap Screw G—Supporting Stand T122532 –UN–05AUG99 Continued on next page DW90712,0000076 –19–09FEB06–1/7 4-5-4 010609 PN=247