Miscellaneous—Machine Assembly 4. Check that hose (A) does not come into contact with frame (B). In cases where the gap between the hose and the frame is less than 5 mm (0.2 in), loosen the control valve side hose connector (C). Then, adjust the hose angle, so that the gap between the hose and the frame is increased. T122539 –UN–05AUG99 NOTE: Check the gap between the hose and the frame with the front attachment positioned as illustrated to the right. (The gap between the hose and the frame is reduced to a minimum when the front attachment is positioned as illustrated.) 5. To adjust the hose angle, loosen three or four cap screws at hose connector (C). Then, twist hose adapter downward.
(Hose angle is set to 10 ° before the machine is shipped from the factory. However, depending on the hose bending tendency or the direction of the boom side hose connector, the gap between the hose and the frame may vary. Therefore, be sure to check the gap and adjust as required.) T122541 –UN–05AUG99 A—Hose B—Frame C—Connector T122542 –UN–05AUG99 DW90712,0000083 –19–10FEB06–2/2 4-5-10 010609 PN=253