4-6-23 010609 PN=287 Miscellaneous—Operational Checkout NOTE: Swing speed should not slow when actuating arm in. LOOK: Does swing speed remain unchanged when actuating arm in? YES: Go to next check. NO: See your authorized dealer. –19– –2/2 Control Valve Lift Check Test T6292AZ –UN–19OCT88 1—Engine Speed Dial Turn engine speed dial (1) to slow idle to (L) position. Position machine as shown. Slowly lower boom, extend arm (retract cylinder), and dump bucket (retract cylinder). TX1000874 –UN–01DEC05 LOOK: Do functions move in opposite direction as pilot control levers are first moved, then change direction as levers are moved further? YES: See your authorized dealer. NO: Go to next check.
– – –1/1 Boom Up, Arm In, and Bucket Combined Function Operation Check 1—Engine Speed Dial 2—Auto-Idle Switch 3—Power Mode Switch Turn engine speed dial (1) to fast idle (H) position. Turn power mode switch (3) to P (power) mode. Actuate boom up function, arm in function and then bucket function in combination. TX1000170 –UN–10NOV05 LOOK: Does boom continue to move at approximately the same speed after bucket function is actuated? YES: Go to next check. NO: See your authorized dealer. – – –1/1