Operation—Operating the Machine IMPORTANT: To ensure full thread engagement of cap screw (B) in yoke (D), length (A) must not exceed 110 mm (4.33 in.) NOTE: In order to achieve proper alignment of tie bolts and counterweight bosses to machine mainframe, length (A) of each adjusting cap screw (B) may vary from side to side of counterweight. 10. Adjust cap screw (B) on each yoke (D) to length (A). Tighten nut (C). Counterweight—Specification Head of Cap Screw to Yoke— Length 105 mm (4.13 in.) approximate ....................................................... 11. Slowly raise counterweight to full height. 12. Check counterweight boss and tie bolt alignment. 13.
As necessary, lower counterweight and adjust length (A). To raise counterweight, decrease length. To lower counterweight, increase length. T8174AL –UN–23SEP94 A—105 mm (4.13 in.) Approximate B—Adjusting Cap Screw (2 used) C—Nut (2 used) D—Yoke (2 used) E—Yoke-To-Counterweight Pin (2 used) F—Washer (2 used) G—Lock Pin (2 used) H—Flat Washer (2 used) Continued on next page MD04263,0000095 –19–09DEC08–4/7 2-3-24 010609 PN=94