John Deere 700H Crawler Dozer — Disassemble and Assemble

Axle Shaft, Bearings, and Reduction Gear 41. Install housing alignment dowel pins (1) in housing half. 42. Apply cure primer and plastic gasket to housing sealing surface. 43. Join housing halves. T119802B –UN–25JAN99 44. Install cap screws and tighten evenly to specifications. Final Drive—Specification Final Drive Housing Cap Screws—Initial Torque 135 (100 lb-ft) ................................................ Final Torque 320 (235 lb-ft) ................................................................ 1—Dowel Pins (2 used) CED,TX03399,5970 –19–24MAR00–20/26 45. Seat bearing cup (1) onto bearing cone.

1—Bearing Cup T133214B –UN–21AUG00 TM1859 (14JUL04) 02-0250-9 700H Crawler Dozer Continued on next page CED,TX03399,5970 –19–24MAR00–21/26 071404 PN=139 39. Install first idler cluster gear (1). Heat bearing cone (2) and install onto axle shaft. 40. Install snap ring (3) onto axle shaft. –UN–11DEC98 Select the appropriate snap ring (3) by checking end play on first idler cluster gear and compare to following specifications. 7B Final Drive—Specification T11885 Final Drive First Idler Cluster Gear—End Play........................................... 0—0.241 mm (0—0.0095 in.) 1—First Idler Cluster Gear 2—Bearing Cone 3—Snap Ring CED,TX03399,5970 –19–24MAR00–19/26 02 0250 9