Track System T8063AG –UN–08SEP93 Double Flange Track Roller Shown 1—Inner Collar 6—O-Ring (2 used) 11—Snap Ring (2 used) 16—Bushing (2 used) 2—Lock 7—Shaft 12—O-Ring (4 used) 17—Roller 3—Cap Screw (12 used) 8—Outer Collar 13—Metal Face Seal (2 used) 18—Washer (4 used) 4—Lock Washer (12 used) 9—Plug 14—Bushing Case (2 used) 19—Cap Screw (4 used) 5—O-Ring (2 used) 10—O-Ring 15—Pin (2 used) 9. Assembly of single and double flange roller is the same. Single flange shown. TM1859 (14JUL04) 01-0130-23 700H Crawler Dozer Continued on next page CED,TX03399,5943 –19–24MAR00–5/12 071404 PN=73 NOTE: Metal face seals are matched sets. Seals are not interchangeable with other seals. 6.
Remove and inspect metal face seals. (See Inspect Metal Face Seals in this group.) –UN–26OCT88 7. Remove O-rings (2) from both ends of shaft. NOTE: Shaft, bushings and bushing case are not service, replace with roller assembly. T6018BC 8. Inspect shaft, bushings and bushing case, replace with roller assembly. 1—Cap Screw (12 used) 2—O-Rings CED,TX03399,5943 –19–24MAR00–4/12 01 0130 23