Track System Measure Bushing Outside Diameter NOTE: Lubricated track chain bushings are measured for vertical wear only using calipers. Bushing vertical wear can be measured using the depth gauge method only after bushing turn procedure is used. (See Undercarriage Appraisal Manual, SP326). 1. Clean surfaces to be measured of two adjacent bushings and underside of track shoe in the area between bushings. 2. Measure reverse drive side wear (A) and forward drive side wear (B) of the bushing using a caliper and scale from undercarriage inspection tool kit. Position the caliper so that as it is passed back and forth over the bushing, one tip will slide parallel along with worn surface.
Close caliper until the opposite tip just touches the unworn side of the bushing. Measure several bushings to the nearest 0.5 mm (0.020 in.). Track Bushing Outer Diameter—Specification New Bushing—OD 62.2 mm (2.45 in.) ....................................................... 100 Percent Worn Bushing (High Shock Impact)—OD 55.3 mm ( 2.18 in.) .................................................... 100 Percent Worn Bushing (Normal Impact)—OD 52.8 mm (2.08 in.) ................................................... TM1859 (14JUL04) 01-0130-31 700H Crawler Dozer CED,TX03399,5949 –19–24MAR00–1/1 071404 PN=81 Measure Link Height NOTE: See Undercarriage Appraisal Manual SP326 for additional information.
Measure link height to nearest 0.5 mm (0.020 in.) using a –UN–02NOV88 depth gauge from undercarriage inspection service tool kit. Put the depth gauge on outside of track link against pin boss as shown. Measure several links to the nearest 0.5 mm (0.020 in.). T5802AD Chain Link—Specification Chain Link New—Height............................................ 103.9 mm (4.09 in.) Chain Link 100% Worn—Height.................................. 94.5 mm (3.72 in.) CED,TX03399,5948 –19–24MAR00–1/1 01 0130 31