Track System IMPORTANT: Track press disassembly tools must be in proper alignment with links to prevent broaching of pin and bushing. Damaged link bores cannot be reused. 01 0130 36 5. Start disassembly at pen-end half of split link. Check for proper alignment of tools with pin and bushing. T96266 –UN–27OCT88 6. Make an index mark on bushings to aid in reassembly, when turning bushings 1/2 turn (180 ° ) to expose a new wear surface. CAUTION: Always wear safety glasses when operating the press. Parts may break or chip, which could create a risk of personal injury. A—Left Ram B—Saddle C—Right Ram D—Right Link E—Bushing F—Left Link G—Pin 7.
Extend right ram (C) to push pin (G) and bushing (E) from the right link (D). The right link is forced against the side of saddle (B) as pin and bushing are pushed out. 8. Retract right ram. The right link, with seals and thrust ring, will stay on the ram tools. CED,TX03399,5952 –19–10NOV00–2/5 9. Extend left ram (A) to push the pin (C) and bushing (F) from left link (G). The left link is forced against the side of saddle (B) as pin and bushing are pushed out. 10. Retract left ram. The left link, with seal and thrust ring, will remain on the ram tools. 11. Remove links, bushing, and thrust rings from press.
T96267 –UN–27OCT88 A—Left Ram B—Saddle C—Pin D—Right Ram E—Right Link F—Bushing G—Left Link TM1859 (14JUL04) 01-0130-36 700H Crawler Dozer Continued on next page CED,TX03399,5952 –19–10NOV00–3/5 071404 PN=86