Track System 16. Inspect pin ends. If the chamfer is missing due to wear, grind a 3 mm (0.12 in.) x 15 ° chamfer on pin. If chamfer is missing in stopper hole, add new 4 mm (0.16 in.) x 30 ° chamfer. Lubricated Track—Specification Pin—Chamfer 3 mm (0.12 in.) x 15 ° ........................................................... Pin—Chamfer 4 mm (0.16 in.) x 30 ° ........................................................... T96269 –UN–27OCT88 17. Clean pins, bushings, and thrust rings in solvent. mm (0.16 in.) B—30 ° C—15 ° mm (0.12 in.) CED,TX03399,5952 –19–10NOV00–5/5 TM1859 (14JUL04) 01-0130-37 700H Crawler Dozer 071404 PN=87 12.
Inspect parts as they are disassembled to determine which ones can be reused. If there is internal wear at any joint, replace seal ring, pin, bushing, thrust ring, and load ring. These parts must be replaced to successfully lubricate chain –UN–01NOV88 again. 13. If pin and bushing contains oil when disassembled, new pins, seal rings, bushings, thrust ring and load T6682AJ rings are not necessary. Do not remove usable seals from link counterbore. Do not remove any dirt from around seals. A—Bushing 14. Repeat steps 4—12 to disassemble rest of chain. B—Seal Ring C—Load Ring D—Thrust Ring 15. Remove rubber stopper (F) from pins using a drill.
E—Pin F—Stopper CED,TX03399,5952 –19–10NOV00–4/5 01 0130 37