John Deere 700H Crawler Dozer — Disassemble and Assemble to Turn Pins and Bushings and Not Lubricate

Track System 12. Inspect pin ends for wear. If there is no chamfer (A and B), grind a new chamfer to specification. Specification Lubricated Track Pin End— Chamfer 3 mm (0.12 in.) x 15 ° .................................................................... A—15 ° mm (0.12 in.) T5798AJ –UN–26OCT88 Continued on next page CED,TX03399,5954 –19–24MAR00–4/11 TM1859 (14JUL04) 01-0130-47 700H Crawler Dozer 071404 PN=97 7. Extend left ram (A) to push the pin (C) and bushing (F) from left link (G). The left link is forced against the side of saddle (B) as pin and bushing are pushed out. 8. Retract left ram. The left link, with seal and thrust ring, will remain on the ram tools. –UN–27OCT88 9.

Remove links and bushing from press. 10. Repeat steps 4—9 to disassemble rest of chain. T96267 IMPORTANT: Pins must be installed so cross-drilled hole is toward link wear surface or they may break when chain is used. A—Left Ram B—Saddle C—Pin 11. All pins, bushings, seals, and thrust rings are used for D—Right Ram reassembly, because chain is not lubricated. Do not E—Right Link remove rubber plug and plastic plug from pins. Do not F—Bushing remove seals from track links. G—Left Link Turn pin end-for-end to get a new wear surface, then install it into bushing so cross-drilled hole is toward link wear surface.

Install all pins so hole in end of pin is toward the same side of chain, either left or right side. CED,TX03399,5954 –19–24MAR00–3/11 01 0130 47